Heavy duty twin engine/twin cylinder tie bar kit for use with UC128 and UC128P “Port” version outboard cylinders. Suitable for use with Protech and SilverSteer cylinders these AISI 304 electropolished and passivated stainless steel tie bars are simple to install and allow for independent trimming of engines with minimal effect on engine alignment.
• Suitable for applications with dual UC128-OBF or UC128-SVS (not UC130-SVS) front mount cylinder
NOTE: in applications with single cylinder use A94 tie bar
• Allows to tilt the engines independently
• Electropolished/passivated stainless steel components and ball joints
• Applicable to engine centers variable from 26” (660 mm) to 36” (914,4 mm).
• 6 different lengths available:
A90 x 26 - 42640B - 26” (660,4 mm) twin engine centers
A90 x 28 - 42641D - 28” (711,2 mm) twin engine centers
A90 x 30 - 42642F - 30” (762,0 mm) twin engine centers
A90 x 32 - 42643H - 32” (812,8 mm) twin engine centers
A90 x 34 - 42644K - 34” (863,6 mm) twin engine centers
A90 x 36 - 42645M - 36” (914,4 mm) twin engine centers
WARNING: In the applications with dual UC128-OBF (or UC128-SVS) cylinder it is necessary to order a standard UC128-OBF (or UC128-SVS) cylinder (link arm attached to the starboard side of the cylinder) and a UC128P-OBF (or UC128P-SVS) port cylinder (link arm attached to the port side of the cylinder).
UC128 starboard cylinders:
UC128-OBF/1 - 43231N
UC128-OBF/2 - 43232R
UC128-OBF/3 - 43233T
UC128-SVS/1 - 41281U
UC128-SVS/2 - 41282W
UC128-SVS/3 - 41283Y
UC128P port cylinders:
UC128P-OBF/1 - 43234V
UC128P-OBF/2 - 43235X
UC128P-SVS/1 - 41328U
UC128P-SVS/2 - 41329W
ATTENTION: As the tiller arm position varies from engine to engine and the distance between two engines is not predictable, unexpected interferences may occur while tilting. Checking the cowling clearances with the tie bar at various engine tilt positions and turning angles is required. Should you need additional information, please do not hesitate to refer to our Technical Service.